The Researches on…. (题目14号字加黑居中)
(空一行)
Wang Lanyan, Li Qiang (10号字居中)
School of Management, Tianjin University, Tianjin,P.R.China, 300072 (10号字居中)
(空一行)
Abstract (10号字加黑):Toyota Production System is a complex ……(10号字)
Key words (10号字加黑):Data Envelopment Analysis;Evaluation System…(10号字)
(空一行)
1 Introduction
(一级标题12号字加黑,下0.5行距)
TPS is a new kind of production system after the Single Production System and Mass Production System, providing various products in small patches.
(正文均用10号字)
2 The Improved Method
(一级标题12号字加黑,上下0.5行距)
2.1 Method one
(二级标题10号字加黑)
Table 1 (表头9号字加黑居中)
说明: 1、全篇选用Times New Roman字体,正文双栏;
2、A4纸型,论文不打印页码;
3、可有页脚不可有页眉;
4、文档网格项中选“无网格”,无特殊说明均为单倍行距;
5、如文中的表(三线表)、图和公式较大或较长可排成通栏。
6、页边距设为:上
具体规范
1、标题:所有单词首字母大写(介词、连词 如of , on ,for,and 等用小写)。
例如:An Input Configuration Algorithm for Iron and Steel Material Yard
2、作者姓名:一律姓在前,名在后。姓首字母大写,名连写并首字母大写,中间不加短线。(参考文献中翻译中国作者名字时,也要遵循本标准)。
例如:王兰燕 Wang Lanyan
3、作者单位信息:顺序为:学院,大学,城市(注意,不是省),国别,邮政编码。
例如:天津大学管理学院 School of Management, Tianjin University, Tianjin,P.R.China, 300072
4、摘要栏:摘要词组(或单词)所有单词首字母大写(介词除外),中间用分号隔开。
例如:Data Envelopment Analysis;Evaluation System
5、一级标题:顶格,所有单词首字母大写(介词除外)。
例如: 2 The Improved Method
6、二级标题:顶格,只有第一个单词的首字母大写。
例如:2.2 Establishment of the linear model
7、图和表:
(1)图名或表名: Figure 或Table 的首字母统一大写(文中提到也要大写),如果简写也要全文统一。所有图或表都必须有名字,且要在文中相应位置提到。
例如:Figure 1 Gene representation for job sequencing problem 或 Fig.1 Flow of raw materials management
(2)其他说明:
所有图表一定要规范、清晰。表不要两侧边的墙线;并严格作到文图、文表对应(即图和表在文中要提到,并文中叙述和图、表相符)。
A、插图
1)安排图位的原则是先见文后见图,且文和图位尽可能靠近。(注:图一定要有图名,且要在文中相
应位置提到)。
2) 图按“图名→分图名→图注”的顺序从上至下排,不可颠倒。
1) 图要连续编号,不要断号或跳号。
B、插表
1)安排表位的原则是先见文后见表,且文和表位尽可能靠近。(注:表一定要有表名,且要在文中相
应位置提到)。
2)插表要连续编号,不要断号或跳号。
3) 表头中物理量和单位之间用除(/)的形式表示。表中有文字说明时,起行空一格,回行顶
格,结尾不用标点。
2) 插表转页时,重复书写表头并在上表线右上方加“(续)” 。
8、公式:
(1)公式中的变量须用斜体(包括下角标),与公式对应的变量在文中也必须相应用斜体。
(2)紧接公式的叙述性文字的后面不加标点。
(3)公式中的符号要事先定义或紧接在公式下给出定义(同时注意定义的格式为)。如
区域创新系统网络中的联系是有向关系,因此,它的网络密度衡量方式如下公式所示
式中,n为区域创新系统网络规模;l为网络中实际存在的连线的长度(m)。
说明:(“式中,” 要顶格并加逗号,其后的说明间用分号 ,有单位的在后面有括号把单位括起来,单位符号一律用正体, 结尾用句号)
(4)公式要按照顺序编号,编号都接在公式后面并右对齐。
(5)计算式中的每个计算步骤都应带单位,单位不加括号。
9、外文字母正斜体问题:
(1)作计量单位时一律用正体。
(2)文中外文单词、语句一般用正体。
(3)公式中外文字母(作为变量时)一般用斜体。
10、参考文献:统一用References (首字母大写),参考文献格式应遵循国家标准(见附件)。如
References
[1]Stock J R. Reverse logistics [M].
[2]Schrady D A. A deterministic inventory model for repairable items [J]. Naval Logistics Quarterly,1967(14):391-398.
[3]Richter K. The EOQ repair and waste disposal model with variable setup numbers [J].European Journal of Operational Research.,1996(95):313-324.
[4]Cohen M A, Nahmias S, Pierskalla W P. A dynamic inventory system with recycling[J]. Naval Research Logistics Quarterly,1980, 27(2): 289-296.
[5] Huang Zuqing, Qing Dali. The optimized inventory control strategy based on set period and set volume disposal[J]. Science of southeastern university,2005, 35( 2): 302-307.
[6]Speranza M G, Stahly P. New Trends in Distribution Logistics [M].
[7]Yuan Qingda. Research on the Stochastic Inventory-Transportation Integrated Optimization Problem [D].
11、其他注意事项
(1)一定不要有政治问题。例如,提到台湾,一定要写作中国台湾(地区);如提到香港(澳门),一定要用香港(澳门)特别行政区。
(2)所有年份必须写全,不能简写。例如,98年要写成1998年。
(3)凡涉及表示******或最小时,min, max 都要用小写、正体。如
(4)在公式等处涉及省略时,要采取如下格式(省略号3个点,居中,两边用逗号)。如
(5)
Based on the related researches, this thesis tries to study ITIO problem in view of many-one distributing network and establish the mathematic model which suits to stochastic demand and many products with a bi-level programming model under VMI mode. And a heuristic algorithm is used in the thesis to analyze its solution.
(6)当涉及多个作者和多个单位时,采用如下格式
An Input Configuration Algorithm for Iron and Steel Material Yard
Xu Xuejun1, Tang Qiangrong1,2, He Jiang1
1 School of Business Administration, South China University of Technology, Guangzhou,P.R.China, 510641
2 School of Management, Tianjin University, Tianjin,P.R.China, 300072
Copyright(C) 第十五届工业工程与工程管理国际学术会议